Author: Editor

On April 29, 2010, the US Environmental Protection Agency (EPA) proposed three rules to regulate hazardous air emissions from commercial, institutional and industrial boilers, process heaters and incinerators at major and area sources.

One of the proposed rules addresses boilers at area sources – facilities that potentially emit less than 10 tons per year (tpy) of any single hazardous air pollutant or 25 tpy of combined air toxics. The rule will apply to facilities with boilers that burn coal, oil or biomass (i.e., wood), but not waste materials. New boilers that burn coal would need to meet emission standards for mercury, particulates and carbon monoxide. New boilers burning oil or biomass will need to meet emission limits for particulates and carbon monoxide. Existing large boilers (heat input of 10 million Btu/hr or greater) that burn coal will be required to meet emission limits for mercury and carbon monoxide; existing large boilers that are oil or biomass-fired will have an emission limit for carbon monoxide, only. The rule requires that all facilities with large boilers conduct an energy assessment to identify practicable conservation measures. Facilities with small boilers will be required only to conduct a boiler tune-up at least once every two years.

The second rule applies to boilers and process heaters at major source facilities. The rule will apply to boilers that burn natural gas, fuel oil, coal, biomass or other gas, but not waste, and to process heaters (which heat raw or intermediate materials in an industrial process).
Continue reading “Air pollutant emission standards for boilers and process heaters”

Toxic Chemical Release Inventory (TRI) Form R or Form A reports are due by July 1! If your facility:

• has 10 or more employees;
• is included among certain covered industrial categories, including manufacturers that correspond to SIC Codes 20 through 39; some mining operations; utilities that burn coal or oil for commercial electrical generation; chemical wholesalers; petroleum bulk storage terminals; and waste treatment, disposal and recovery facilities; and
• manufactured, imported, processed or otherwise used listed toxic chemicals above threshold reporting quantities,

Then you are likely required to report your releases and off-site transfers of the toxic chemicals.  More information on these requirements is linked at www.tcozzie.com/guidance/tri/.  You can visit the Environmental Protection Agency’s TRI reporting materials page by clicking on the image at right.

Does your facility need to comply? Are you ready to meet this requirement? As always, feel free to contact T. Cozzie Consulting for further information or assistance.

The Environmental Protection Agency has published its template Spill Prevention, Control and Countermeasure (SPCC) Plan for use by qualified Tier 1 facilities.  To use the template SPCC Plan, a facility can store no more than 10,000 gallons of oil in aboveground storage with no single storage container or tank larger than 5,000 gallons, and cannot have had within the past three years either one spill or release of more than 1,000 gallons or two spills that each exceeded 42 gallons within a 12-month period.

You can download a fill-in PDF version of the SPCC Plan template by clicking (or right click to save) the PDF icon to the right.

Other versions of the SPCC Plan template (MS Word and Wordperfect) can be found on the EPA website.

Remember, the deadline to amend or prepare and implement an SPCC Plan meeting the latest requirements is November 10, 2010.  Visit our spill prevention page for additional information and guidance on compliance with SPCC Plan requirements. Or contact T. Cozzie Consulting if you have further questions about how the SPCC rule applies to your facility, or desire assistance with your SPCC Plan.

On April 6, EPA proposed to add sixteen (16) chemicals to the list of toxic chemicals subject to reporting under section 313 of the Emergency Planning and Community Right-to-Know Act (your Form R or Form A submissions due each July 1). These sixteen chemicals have been classified by the National Toxicology Program as “reasonably anticipated to be a human carcinogen.” Based on its review of available production and use information, EPA has concluded that these sixteen chemicals are manufactured, processed, or otherwise used in quantities that would exceed the EPCRA section 313 reporting thresholds.

The 16 chemicals include:

Continue reading “EPA proposes adding 16 chemicals to Toxic Release Inventory reporting rule”

In a matter of a few weeks, the US Environmental Protection Agency (EPA) has proposed several actions that could have dramatic impacts for facilities subject to Clean Air Act New Source Review (NSR) provisions (i.e., major sources of air pollutant emissions).  These actions address the grandfathering provision for fine particulate emissions, the fugitive emissions rule and the aggregation rule.  To wit:

• On February 4, EPA proposed to repeal the NSR “grandfathering provision” for emissions of particulate matter less than 2.5 microns, or micrometers, in diameter (PM2.5), commonly termed “fine particulates.”  The rule had allowed permit applicants to rely on permitting requirements for “coarse particulates” – particulate matter 10 microns or less in diameter, or PM10 –  as a surrogate for PM2.5 requirements if the application had been submitted prior to July 15, 2008.  The EPA proposal also will end the “PM10 surrogate policy” by no later than May 2011, eliminating the use of PM10 as a substitute for PM2.5 analysis in State permitting programs.

Continue reading “For “major” sources of air pollution, the hits keep coming…”

The US Environmental Protection Agency (EPA) has announced  that Clean Air Act permits for stationary sources of greenhouse gases (GHGs) will not be required before January 2011 – or, to put it another way, EPA has put the largest sources of greenhouse gas emissions on notice that permitting will commence in January 2011.

Clean Air Act construction and operating permit requirements for the facilities emitting the largest quantities of GHGs will begin when the first national GHG control rule takes effect.  EPA’s target date for implementation of a rule regulating GHG emissions from cars and light trucks is January 2011, when model year 2012 vehicles meeting the standards can first be sold in the United States.  Final greenhouse gas emissions standards for vehicles are pending.

At this point, potentially regulated sources are still waiting for EPA to formally reveal the threshold quantities of GHG emissions that will trigger the requirement for permit limitations on these emissions.

What do you think – too soon?  Can we expect that regulators and regulated industries will be able to identify, engineer and implement effective control technologies and procedures in timely fashion?  And how will the costs affect not only the permitted industries but also chances for an economic recovery?

More information on the EPA approach and its intended timeline can be found at www.epa.gov/nsr/guidance.html.